6 L4-2.5L (2010)
prevent injury while disposing of the air bag module, make sure to operate (deploy) both driver-side air bag module inflators simultaneously,
following the procedure below.
1. Remove the driver-side air bag module. See: Air Bag Systems/Air Bag/Service and Repair/Removal and Replacement/Driver-Side Air Bag
Module Removal/Installation
2. Install the bolts to the driver-side air bag module as shown in the figure, and connect the SST (Adapter harness).
3. Place the driver-side air bag module on the center of the tire wheel with the padded surface facing up. To secure the air bag module to the tire
wheel, wrap a wire (cross 1.25 mm2 {0.002 in2} or more) through the wheel and the bolt installation holes of the air bag module at least 4 times.
WARNING:
-
If the air bag module is not properly installed to the tire wheel, serious injury may occur when the module is operated (deployed). When
installing the air bag module to the tire wheel, make sure the padded surface is facing up.
4. Stack three tires without wheels on top of the tire with the driver-side air bag module, and then stack another tire with a wheel on the very top.
5. Secure the tires with wire.
6. Connect the SSTs (Deployment tool) to the SSTs (Adapter harness).
