6 L4-2.5L (2010)
Control Arm: Service and Repair
Front Upper Arm Removal/Installation
FRONT UPPER ARM REMOVAL/INSTALLATION
CAUTION:
-
Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is
pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place
where the sensor will not be pulled by mistake while servicing the vehicle.
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. Inspect the front wheel alignment. See: Alignment/Service and Repair/Front Wheel Alignment
Front Upper Arm Ball Joint Removal Note
1. Support the knuckle using the jack.
2. Separate the ball joint from the knuckle using the SST.