6 L4-2.5L (2010)
1. Align the marks, and slide the oil hose onto the oil pipe until it is fully seated as shown.
2. Install the hose clamp.
3. Install the hose clamp onto the hose.
4. Verify that the hose clamp does not interfere with any other components.
Oil Cooler Removal/Installation - FS5A-EL
OIL COOLER REMOVAL/INSTALLATION [FS5A-EL]
1. Disconnect the negative battery cable.
2. Remove the air cleaner component. See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair
3. Remove the aerodynamic under cover NO.2. See: Body and Frame/Splash Guard/Service and Repair/Aerodynamic Under Cover No.2
Removal/Installation
4. Drain the ATF into a separate suitable container. See: Service and Repair/Procedures/Automatic Transaxle Fluid (ATF) Replacement - FS5A-EL
5. Drain the engine coolant. See: Engine, Cooling and Exhaust/Cooling System/Coolant/Service and Repair
6. Remove in the order indicated in the table.
7. Install in the reverse order of removal
8. Add the engine coolant. See: Engine, Cooling and Exhaust/Cooling System/Coolant/Service and Repair
9. Add the ATF. See: Service and Repair/Procedures/Automatic Transaxle Fluid (ATF) Replacement - FS5A-EL
10. Perform the "Line Pressure Test". See: Transmission Control Systems/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Mechanical System Test - FS5A-EL
Type A
