6 L4-2.5L (2010)
4. Tighten the bolts in the order shown in the figure.
Tightening torque
-
8-12 Nm {82-122 kgf-cm, 72-105 in-lbf}
5. Install the connector of the VSS and input/turbine speed sensor to the solenoid clamp.
CAUTION:
-
If the control valve body cover is installed with the wiring harnesses overlapped, the wiring harnesses may be pinched between the cover and
valve body causing the wiring harnesses to be damaged. Therefore, verify that the wiring harnesses are not overlapped when installing the
control valve body cover.