6 L4-2.5L (2010)
Pressure Plate: Testing and Inspection
CLUTCH COVER INSPECTION
1. Refer to CLUTCH UNIT REMOVAL/INSTALLATION to remove the clutch cover. See: Service and Repair
2. Measure the wear of the diaphragm spring fingers.
-
If it exceeds the maximum specification, replace the clutch cover. See: Service and Repair
Clutch cover diaphragm spring fingers maximum depth
-
0.6 mm {0.02 in} max.
3. Measure the flatness of the pressure plate with a straight edge and a feeler gauge.
-
If it exceeds the maximum specification, replace the clutch cover. See: Service and Repair
Maximum clearance of flatness of the pressure plate
-
0.3 mm {0.01 in} max.
4. When checking the diaphragm spring fingers, mount a dial indicator on the cylinder block.
5. Rotate the flywheel and check for misaligned diaphragm spring fingers.
-
If it exceeds the maximum specification, replace the clutch cover. See: Service and Repair
Clutch cover diaphragm spring fingers maximum misalignment
-
1.0 mm {0.039 in} max.