6 V6-30L (2007) Air Flow Meter/Sensor Locations
Air Flow Meter/Sensor: Testing and Inspection
MASS AIR FLOW (MAF) SENSOR INSPECTION[AJ]
NOTE: Perform the following inspection only when directed.
Visual Inspection
1. Visually inspect for the following on the MAF/IAT sensor.
-
Damage
-
Cracks
-
Bent terminals
-
Terminal rust
-
If any of the above are found, replace the MAF/IAT sensor.
MAF Rate and Load Value
Specification
NOTE: The scan tool shows the MAF rate and load value.
Circuit Open/Short Inspection
1. Disconnect the PCM connector.
2. Inspect the following harnesses for open or short circuit. (Continuity check)
Open circuit
-
MAF/IAT sensor terminal A and main relay terminal C
-
MAF/IAT sensor terminal B and PCM terminal 1 P
-
MAF/IAT sensor terminal C and PCM terminal 1AK
Short circuit
-
MAF/IAT sensor terminal A and body ground
-
MAF/IAT sensor terminal B and power supply
-
MAF/IAT sensor terminal C and power supply