6 V6-3.0L (2007)
should be inspected.
-
Be sure the negative battery terminal is disconnected before replacing a main fuse.
-
When replacing a pullout fuse, use the fuse puller.
ELECTRICAL TROUBLESHOOTING TOOLS
Jumper Wire
-
A jumper wire is used to create a temporary circuit Connect the jumper wire between the terminals of a circuit to bypass a switch.
CAUTION: Do not connect a jumper wire from the power source line to a body ground. This may cause burning or other damage to
wiring harnesses or electronic components.
Voltmeter
-
The DC voltmeter is used to measure circuit voltage A voltmeter with a range of 15 V or more is used by connecting the positive (+) probe (red
lead wire) to the point where voltage will be measured and the negative (-) probe (black lead wire) to a body ground.