6 V6-3.0L (2007)
Side Air Bag: Service and Repair
Side Air Bag Module
SIDE AIR BAG MODULE REMOVAL/INSTALLATION
WARNING:
-
Handling the air bag system components improperly can accidentally operate (deploy) the air bag modules and pre-tensioner seat belts,
which may seriously injure you. Read the service warnings and cautions before handling the air bag system components.
-
If the side air bag module is installed with debris in the seat back, the foreign material may be scattered when the side air bag module
operates (deploys), causing injury. Verify that there is no foreign material in the seat back before installing the side air bag module.
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. Turn the ignition switch to the ON position.
4. Verify that the air bag system warning light illuminates for approx. 6 s and goes out.
-
If the air bag system warning light does not operate in the manner described above, there are malfunctions in the system. Inspect the system
using the on-board diagnostic.
Connector Removal Note
1. Using a flathead screwdriver, pry out the connector's stopper plate.
2. Disconnect the connector.