6 V6-3.0L (2007)
Clutch Switch: Testing and Inspection
STARTER INTERLOCK SWITCH INSPECTION (MTX) [L3, AJ]
On-vehicle Inspection
1. Inspect the following.
-
With the clutch pedal not depressed, verify that the engine does not start.
-
With the clutch pedal fully depressed, verify that the engine starts.
-
If not as specified, perform continuity inspection.
Continuity Inspection
1. Disconnect the starter interlock switch connector.
2. Verity that the continuity is as indicated in the table.
-
It there is any malfunction, replace the starter interlock switch.
