6 V6-3.0L (2007)
Power Steering Pressure Switch: Testing and Inspection
POWER STEERING PRESSURE (PSP) SWITCH INSPECTION[AJ]
NOTE: Perform the following inspection only when directed.
Continuity Inspection
1. Inspect the following if the power steering is inoperative:
-
Power steering fluid level
-
Power steering fluid leakage
-
Power steering fluid pressure
2. Disconnect the PSP switch connector.
3. Start the engine.
Specification
4. Inspect for continuity between PSP switch terminal A and body ground using an ohmmeter.
-
If the PSP switch is okay, but the PID value is out of specification, perform the "Circuit Open Short Inspection".
-
If not as specified, replace the PSP switch.
Circuit Open/short Inspection
1. Disconnect the PCM connector.