6 V6-3.0L (2007)
Transmission Speed Sensor: Testing and Inspection
Input/Turbine Speed Sensor Inspection
[FS5A-EL]
INPUT/TURBINE SPEED SENSOR INSPECTION [FS5A-EL]
Caution: Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign
objects on the connector when disconnecting it.
1. Disconnect the negative battery cable.
2. Remove the battery and battery tray.
3. Remove the air cleaner component.
4. Disconnect the input/turbine speed sensor connector.
5. Measure resistance between the terminals of the input/turbine speed sensor.
^
If not as specified, replace the input/turbine speed sensor.
Input/turbine speed sensor resistance 250 - 600 ohms (ATF temperature: -40 - 160°C (-40 - 320°F))
6. Connect the input/turbine speed sensor connector.
7. Install the air cleaner component.
8. Install the battery and battery tray.
9. Connect the negative battery cable.
[AW6A-EL]
INPUT/TURBINE SPEED SENSOR INSPECTION [AW6A-EL]
On-Vehicle Inspection
Caution:
^
Water or foreign material entering the connector can cause a poor connection or corrosion. Be sure not to allow water or foreign
material on the connector when disconnecting.
^
Do not damage the terminals.
