6 V6-3.0L (2007)
7. Remove the bracket.
8. Remove the solenoid valve(s).
9. Apply ATF to a new O-ring and install it on the solenoid valve.
10. Install the solenoid valve in the secondary control valve body.
Tightening torque 7.8 - 10.8 N-m (80 - 110 kgf-cm, 70 - 95.4 in-lbf)
11. Install the secondary control valve body.
12. Install the oil cover.
13. Install the under cover.
14. Connect the negative battery cable.
15. Add ATF.
16. Perform the mechanical system test. (See MECHANICAL SYSTEM TEST [FS5A-EL].) See: Transmission Control Systems/Testing and
Inspection/Initial Inspection and Diagnostic Overview/Mechanical System Test
17. Perform the road test. (See ROAD TEST [FS5A-EL].) See: Transmission Control Systems/Testing and Inspection/Initial Inspection and
Diagnostic Overview/Road Test
Primary Control Valve Body Removal
PRIMARY CONTROL VALVE BODY REMOVAL [FS5A-EL]
On-Vehicle Removal
Warning: Using compressed air can cause dirt and other particles to fly out, causing injury to the eyes. Wear protective eyes whenever
using compressed air.
Caution:
^
Clean the transaxle exterior throughout with a steam cleaner or cleaning solvents before removal.
^
If any old sealant gets into the transaxle during installation of the oil pan, trouble may occur in the transaxle case and oil pan. Clean
with cleaning fluids.
1. Disconnect the negative battery cable.
2. Drain the ATF into a separate suitable container.
3. Remove the under cover.
4. Remove the front tires and splash shield.
5. Remove the crossmember.
6. Remove the oil pan.
7. Disconnect the solenoid connectors and GND.
