6 V6-3.0L (2007)
2. Disconnect the cord assembly connector.
3. Start the engine, with gear position in N or P.
4. Reaffirm that there is no continuity between cord assembly terminal and ground.
5. Firmly depress the brake pedal with the left foot.
6. Shift the selector lever to D range.
7. Verify that there is continuity between oil pressure switch terminal and ground.
^
If not as specified, replace the oil pressure switch.
8. Connect the oil pressure switch connector.
9. Install the under cover.
10. Connect the negative battery cable.
Off-vehicle inspection
1. Remove the oil pressure switch.
2. Apply air pressure at 400 - 440 kPa (4.1 - 4.4 kgf/cm2, 58 - 63 psi)