6 V6-3.0L DOHC (2003)
Air Bag Control Module: Service and Repair
SAS CONTROL MODULE REMOVAL/INSTALLATION
WARNING: Handling the SAS control module improperly can accidentally deploy the air bag modules and pre-tensioner seat belt, which may
seriously injure you. Read AIR BAG SYSTEM SERVICE WARNINGS before handling the SAS control module. (See AIR BAG SYSTEM
SERVICE WARNINGS.)
1. Turn the ignition switch to the LOCK position.
2. Disconnect the negative battery cable and wait for more than 1 minute.
3. Partially peel off the floor covering.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Turn the ignition switch to the ON position.
7. Verify that the air bag system warning light illuminates for approximately 6 seconds and then goes off.
-
If the air bag system warning light does not operate in the manner described above, there are malfunctions in the system. Inspect the system
using the on-board diagnostic.