6 V6-3.7L (2009)
Acceleration/Deceleration Sensor: Testing and Inspection
COMBINED SENSOR INSPECTION
1. Switch the ignition to off.
2. Connect the M-MDS to the DLC-2.
3. Select the following PIDs and inspect the lateral acceleration and yaw rate. See: Testing and Inspection/Scan Tool Testing and
Procedures/On-Board Diagnosis [Dynamic Stability Control (Dsc)]
-
LAT_ACCL (lateral acceleration)
-
YAW_RATE (yaw rate)
a. Lateral acceleration inspection
i.
Verify the LAT_ACCL change when the combined sensor is tilted to the left and right.
-
If there is any malfunction, replace the combined sensor. See: Yaw Rate Sensor/Service and Repair
Standard
-
When the sensor is tilted to the right (A):
LAT_ACCL changes positively.
-
When the sensor is tilted to the left (B):
LAT_ACCL changes negatively.
b. Yaw rate inspection
i.
Verify the YAW_RATE change when the combined sensor is rotated to the left and right.
-
If there is any malfunction, replace the combined sensor. See: Yaw Rate Sensor/Service and Repair
Standard
-
When the sensor is rotated to the right (A):
YAW_RATE changes negatively.
-
When the sensor is rotated to the left (B):
YAW_RATE changes positively.