626 L4-1998 cc 2.0L SOHC Turbo FE (1986)
Throttle Sensor Tester Connection
ADJUSTMENT OF THROTTLE SENSOR SETTING
NOTE:
Adjustment of the throttle sensor setting is usually unnecessary. However, if the throttle sensor is replaced or found to be incorrectly adjusted as a result
of the inspection procedure, adjustment must be made.
1.
Disconnect the connector from the throttle sensor and connect the Throttle Sensor Tester (4992 00 165).
Checking The Throttle Stop Screw
2.
Place a 0.40 mm (0.016 in.) thickness gauge between the lever and the throttle stop screw.
Rotating The Throttle Sensor
3.
Loosen the two attaching screws.
4.
Rotate the throttle sensor clockwise about 30 degrees, then rotate it back counterclockwise until the buzzer sounds.
5.
Lightly tighten the two attaching screws.
NOTE:
Be careful not to disturb the throttle sensor position.