626 L4-2184cc 2.2L SOHC F2 (1989)
7. Remove the oil seal with a flat-tipped screwdriver.
8. Tap the new oil seal into the transaxle case with the SST.
NOTE
a. Tap in until the oil seal installer contacts the case.
B. Coat the oil seal lip with transaxle oil.
9. Replace the driveshaft end clip with a new one. Insert the clip with the gap at the top of the groove.
10. Install the driveshaft as follows:
1. Pull the front hub outward, then fit the driveshaft into the transaxle.
2. Insert the driveshaft into the transaxle by pushing on the wheel hub assembly.
NOTE