626 L4-2184cc 2.2L SOHC Turbo F2 (1988)
B.
In Engine Compartment
1)
Connect the black coupler to the solenoid valve which was installed in step 1.
2)
Disconnect the coupler from the No. 1 main relay and install 2 ends of the wire harness between the main relay and its coupler.
3)
Fasten the wire harness with bands.
NOTE:
Apply a sealing agent fully around the rubber seal. Otherwise, water or gas fumes may seep into the passenger compartment.
3.
Adjust the idle speed to the upper limit of specification according to the Workshop Manual.
4.
Verify that no negative pressure is applied to the pressure regulator for 15 seconds after starting the engine.
5.
Attachment of Vacuum Hose Label (for California specifications only)
A)
Clean the present vacuum hose label.
B)
Attach the new label on the cleaned part.
Vacuum Hose Label for Non-Turbo: GJY1 69 036
Vacuum Hose Label for Turbo:
GJY2 69 036
Warranty Information
Customer Comment Code:
99
Damage Code:
99
Part No. of Main Cause:
8AG2 13 SPX0
Operation No:
XX0248RX
Labor Hour:
1.0 Hr.
Technical Service Bulletin # 406189
Date: 891117
Fuel - Rough Idle Within 15 Seconds After Cold Start
Category 4
Applicable Model/s 1988-1989 626/MX-6
Subject ROUGH IDLE AFTER COLD START
Bulletin No.
061/89
Issued
11/17/89
Revised
DESCRIPTION
If the following conditions occur within 15 seconds after a cold start on a 1988-89 626/MX-6, install a repair kit according to the procedures shown in
this bulletin.
NOTE:
The repair kit cuts the negative pressure applied to the pressure regulator for 15 seconds after starting the engine to compensate the air/fuel ratio.
A)
Engine speed drops excessively for a few seconds after starting and then occasionally stalls.