626 L4-2184cc 2.2L SOHC Turbo F2 (1988)
Input Shaft: Technical Service Bulletins
A/T - MTX Primary Shaft Revision
Category Applicable Model/s
7
1988-89 MX-6/626
1988-89 323 Turbo
Subject:
MTX PRIMARY SHAFT
Bulletin No. 050/88
Issued
11/4/88
Revised
DESCRIPTION
A diameter of the primary shaft end portion has been increased to 0.94 in (24 mm) from 0.87 in (22 mm) as shown below in order to increase the strength
of the threaded portion of the primary shaft.
Due to the modification, the synchronizer gear sleeve and lock nut shown in the illustration have also been modified accordingly. Therefore, the
modified primary shaft must be installed together with the modified synchronizer gear sleeve and lock nut.
VIN OF PRODUCTION CHANGE
1989 MX-6/626 vehicles produced in Japan:
JM1GD**** K1709751
August 1, 1988
1989 MX-6 vehicles produced in the U.S.A.:
1YVGD31A7 K5206170
September 14, 1988
1989 323 Turbo vehicles:
JM1BF234* K0314527
August 1, 1988