626 ES V6-2.5L DOHC (1997)
ABS Light: Symptom Related Diagnostic Procedures
Flowchart No. 3 Symptom ABS warning light does not illuminate with ignition switch at ON (engine stopped)
Possible cause
^
Burnt ABS warning light bulb
^
Damaged instrument cluster
^
Damaged ABS control module
^
Open or short circuit in wiring harness
^
Poor connection of connector
Step 1
1. Disconnect the ABS control module connector and turn the ignition switch to ON.
Terminal Identification
Action Chart
2. Ground terminal 2L (L/Y) of the ABS control module connector and verify that the warning light illuminates.
Step 2
Bulb Inspection
Action Chart
1. Remove the instrument cluster.
2. Remove and check the ABS warning light bulb.