626 LX L4-2.0L DOHC (1999)
4. Install and tighten the mounting nuts to the specified torque.
Tightening torque: 47 - 62 Nm 8.7 - 6.4 kgf.m, 33 - 46 ft. lbs.}
TOTAL TOE-IN ADJUSTMENT
1. Adjust the steering angle.
2. Remove the steering gear boot clamp.
3. Loosen the left and right tie rod locknuts and turn the tie rods equally. Both tie rods are right threaded, so turning the right tie rod toward the front
of the vehicle and the left toward the rear increases toe-in.
NOTE: Turning both tie rods one complete turn changes toe-in by about 6 mm {0.24 inch} (0°36').
4. Tighten the tie rod locknuts to the specified torque.
Tightening torque: 69 - 98 Nm {7.0 - 10.0 kgf.m, 50.7 - 72.3 ft. lbs.}
5. Verify that the boot is not twisted, and install the boot clamp.
