626 LX V6-2.5L DOHC (1997)
Alignment: Service and Repair
Front Wheel Alignment
TOTAL TOE-IN
1. Remove the steering gear boot clamps.
2. Loosen the left and right tie rod locknuts, and turn the tie rods equally. Both tie rods are right threaded, so turning the right tie rod toward the front
of the vehicle and the left toward the rear increases toe-in.
NOTE: Turning both tie rods one complete turn changes toe-in by about 6 mm (0.24 inch).
3. Tighten the tie rod locknuts to 60 - 98 Nm (51 - 72.3 ft. lbs.).
4. Verify that the boots are not twisted and install the boot clamps.
MAXIMUM STEERING ANGLE
1. Remove the steering gear boot clamps.
