mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Driveshaft - Pinging Noise|Page 3332 > < Driveshaft - Pinging Noise|Page 3326
Page 1
background image

Center Support: All Technical Service Bulletins
Driveshaft - Pinging Noise

Bulletin No.: 001/93 
Issued: 5/26/96
Revised

Category

L

Applicable Model/s
1992-93 929

Subject:
NOISE FROM UNDER THE CENTER FLOOR AREA

APPLICABLE MODELS/VINS
929 Models

1992 - Vehicles with a VIN of JM1HD****N0100001 through JM1HD****N0999999
1993 - Vehicles with a VIN of JM1HD****P0200001 through JM1HD****P0205786

DESCRIPTION

A metallic pinging noise may be heard when releasing the foot brake in stop and go traffic or engaging reverse or drive while maneuvering to park. The
noise is most evident after continuous driving of more than 30 miles.

The noise is caused by lubrication breakdown in the propeller shaft center support bearing. A new bearing is available to correct this condition.

REPAIR PROCEDURE

If the metallic pinging noise is heard, replace the center support bearing with the new part. Removal and installation procedures are outlined in Section L
of the applicable Workshop Manual.

Driveshaft - Pinging Noise|Page 3332 > < Driveshaft - Pinging Noise|Page 3326