B2300 L4-2.3L (2008)
Seals and Gaskets: Service and Repair
Automatic Transmission Manual Control Lever Shaft Seal Removal / Installation
AUTOMATIC TRANSMISSION MANUAL CONTROL LEVER SHAFT SEAL REMOVAL / INSTALLATION
Removal
Note:
^
It is not necessary to remove the transmission fluid filter to perform this procedure.
1. Remove the automatic transmission oil pan.
2. Remove the digital transmission range (TR) sensor.
Caution:
^
Do not damage the valve inner lever pin.
3. Remove the manual valve inner lever nut.
4. Remove the manual valve inner lever and the parking lever actuating rod.
Caution:
^
Do not damage the case fluid pan rail.
5. Remove the manual control lever shaft spring pin.
^
Tap lightly on each side of the manual control lever shaft spring pin with a drift punch.
^
Pry the spring pin out of its bore.
6. Remove the manual control lever shaft.