B2300 L4-2.3L VIN D (2004)
5. Remove the restraint system diagnostic toot from the clocksp ring electrical connector at the top of the steering column.
6. Position the driver air bag module.
^
Connect the driver air bag module electrical connector.
^
Position the driver air bag module to the steering wheel.
7. Install the two driver air bag module bolts (one shown).
Warning : The restraint system diagnostic tool is for restraint system service only. Remove from vehicle priorto road use. Failure to remove
could result in injury and possible violation of vehicle safety standards.
8. Make sure all restraint system diagnostic tool(s) that may have been installedduring the repair have been removed from the vehicle and all SRS
components are connected.
9. Turn the ignition from OFF to ON.
10. Install the restraint system control module fuse 8 (1OA) to the SJB.
Warning : The restraint system diagnostic tool is for restraint system service only. Remove from vehicle priorto road use. Failure to remove
could result in injury and possible violation of vehicle safety standards.
Warning : Be sure that nobody is in the vehicle and that there is nothing blocking or set in front of any air bag module when the battery
ground cable is connected.
11. Connect the negative battery cable.
12. Prove out the supplemental restraint system (SRS) as follows:
