B2300 L4-2.3L VIN D (2004)
Wheel Fastener: Service and Repair
Rear Axle
WHEEL HUB BOLT CIRCLE RUNOUT
Note:
^
The brake discs/drums must be removed to perform all runout measurements.
1. Position the Dial Indicator with Bracketry perpendicular to the wheel hub or axle flange bolt, as close to the hub or flange face as possible. Zero
the indicator to allow the pointer to deflect either way.
2. Rotate the hub or flange until the next bolt is contacted. Record the measurement and continue until each bolt is checked. The difference between
the maximum and minimum contact readings will tee the total wheel hub or axle flange bolt pattern runout. The runout must not exceed 0.38 mm
(0.015 inch).