B2300 Regular Cab 2WD L4-2.3L VIN A (1997)
Evaporator Core: Service and Repair
Removal/Installation
NOTE
-
If evaporator is replaced, flush the system and replace the suction accumulator/drier.
1. Disconnect negative battery cable.
2. Discharge the refrigerant system.
3. Remove in the order shown in the figure.
4. Install in the reverse order of removal
NOTE
-
The blower motor can be serviced without removing the evaporator assembly. To remove motor, remove cruise control servo bracket (if equipped)
and 4 screws.
NOTE
-
After disconnecting line, cap the openings to prevent entry of dirt and moisture.