B2300 SE Regular Cab 2WD L4-2.3L VIN A (1997)
Electronic Brake Control Module: All Technical Service Bulletins
RABS Module - ABS MIL ON/DTC 5 Set
Bulletin No.: 001/98
Issued: 03/18/98
Revised: 05/20/98
Category
P (04)
Applicable Model/s
1997 B-Series 4WD
Subject
ABS LIGHT ILLUMINATES AFTER FRONT WHEEL LOCK-UP IN 4WD (DTC 5)
BULLETIN REVISION NOTE
^
The "Category" (number) has been revised.
APPLICABLE MODEL(S)/VINS
All 1997 B-Series built up to 6/97 with electric shift control, 4WD with rear ABS.
DESCRIPTION
The Anti-lock Brake System (ABS) Malfunction Indicator Light (MIL) may illuminate after front brake lock-up during 4WD mode. Diagnostic Trouble
Code (DTC) 5 may also be stored in memory. This concern may be caused by the Rear Anti-lock Brake System (RABS) module not sensing that the
vehicle is in 4WD mode. A service kit is now available to provide the proper 4WD signal to the RABS module.
Note
^
The ABS light will turn off after the vehicle's ignition is turned off. It will not illuminate again until the above condition or some other error
occurs; however, DTC 5 will remain stored in memory as a pending code.
Customers complaining of this concern should have the vehicle inspected and if necessary, have the service kit installed.
REPAIR PROCEDURE
1.
Verity the concern.
^
If the concern is present, install the service kit.
^
If the concern is not found, refer to the workshop manual for troubleshooting and repair instructions.
Caution
^
Use care when testing the brakes to ensure control of the vehicle at all times.
2.
Verify the repair.
PART(S) INFORMATION
Part Number
Description
Qty.
ZZN0-67-035
Rear Anti-lock Brake
1
System Service Kit
Note
^
RABS Service Kit includes:
- One (1) Connector not used in this repair
- One (1) Wire (Pre-terminated on both sides)
- One (1) Instruction Sheet
WARRANTY INFORMATION