mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

A/C - MIL ON, Lack of Heat DTC P0125 Set|Page 1380 > < Temperature Sensor (Gauge)|Service and Repair
Page 1
background image

Thermostat: Technical Service Bulletins
A/C - MIL ON, Lack of Heat DTC P0125 Set

Bulletin No.: 019/99
Issued: 06/17/99
Revised:

Section
01

Applicable Model/s
1994-97 B-2300 
1998-99 B-2500

Subject
LACK OF HEAT - MIL "ON" DTC P0125

APPLICABLE MODEL(S)/VINS
All 1994-97 B-2300 and all 1998-99 B-2500.

DESCRIPTION
A lack of heat from the climate control system may occur in some vehicles. Also, the Malfunction Indictor Lamp (MIL) illuminates with Diagnostic
Trouble Code (DTC) P0125 stored in memory. This can be caused by sand from the engine block manufacturing process getting trapped within the
thermostat, causing it to stick open.

Customers having this concern should have their vehicle repaired using the following procedure.

REPAIR PROCEDURE

1.

Verify customer concern.

2.

Flush engine coolant using the procedure in Workshop Manual (section 01 - ENGINE COOLANT FLUSHING).

Note

When using the above procedure, replace both the thermostat and coolant. Be sure to install the thermostat listed below.

3.

Verify repair.

PART(S) INFORMATION

WARRANTY INFORMATION

Note

This information applies to verified customer complaints on vehicles covered under normal warranty. Refer to the SRT microfiche for warranty term
information.

Warranty Type

A

Symptom Code

59 OR 6X

Damage Code

93

Part Number Main Cause

ZZPO 15 171A

Quantity

1

Operation Number/Labor Hours

E0102ARX / 0.5 1994-97 Models
EO1O2BRX / 0.7 1998-99 Models
FOOO8XDX 11.8 max Diagnosis (should be less than 0.5)

A/C - MIL ON, Lack of Heat DTC P0125 Set|Page 1380 > < Temperature Sensor (Gauge)|Service and Repair