B2300 SE Regular Cab 2WD L4-2.3L VIN A (1997)
Clutch Hub And Sleeve Assembly (1st/2nd) (4)
NOTE: When installing the clutch hub and sleeve (1st/ 2nd), make sure that the smaller width of the sleeve faces the 2nd gear side. The reference
marks face the rear of the transmission.
Center Bearing (9, 10)
^
Press the center bearing onto the secondary shaft using the SSTs and sleeve.
NOTES:
^
Fabricate a sleeve where the inside diameter is large enough to fit over the secondary shaft but small enough to engage the inner bearing race.
^
SST Numbers: 49 1243 465A and 49 UN17 101 Shaft Collar and 49 H027 002 Bearing Plate.
Clutch Hub And Sleeve Assembly (3rd/4th) (14)
1. Mate the clutch hub synchronizer key groove with the slants on the inner surface of the clutch hub sleeve
NOTE: The turned edge of the clutch hub sleeve should face toward 4th gear.
2. Install the longer flange on the clutch hub sleeve toward the 3rd gear side
NOTE:
^
The 3rd gear synchronizer ring has three teeth cut out 120° apart from each other. Directly adjacent to one side of the missing teeth, two
teeth have been bridged together.
^
The front and rear sides of the clutch hub may appear to be similar. Install the clutch hub with the chamfer facing 4th gear.
3. Measure the 3rd/4th clutch hub end play with the original retaining ring installed. Standard end play is within 0.00 - 0.05 mm (0.00 - 0.0020
inch).
