mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Sensors and Switches - Body and Frame > < Front Seat Track - 60 Percent Bench|Page 3920
Page 5
background image

6. Install the spring clip on the recliner handle. Install the recliner handle
7. Install the spring.

Vehicles without safety belt buckle pretensioners 

8. Restore the vehicle to operating condition.

1. Install the front seat backrest. 

WARNING:  To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the seat
removal and installation procedure.

2. Install the affected seat.

Vehicles with safety belt buckle pretensioners

9. Restore the vehicle to operating condition.

1. Install the front seat backrest. 

WARNING:  To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the safety
belt buckle and pretensioner removal and installation procedure.

2. Install the safety belt buckle and pretensioner. 

WARNING:  To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the seat
removal and installation procedure.

3. Install the affected seat.

WARNING:  To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before
repairing or replacing any front or side air bag supplemental restraint system (SRS) components and before servicing, replacing,
adjusting or striking components near the front or side air bag sensors, such as doors, instrument panel, console, door latches,
strikers, seats and hood latches.

To deplete the backup power supply energy, disconnect the negative battery cable and wait at least one minute. Be sure to disconnect auxiliary
batteries and power supplies (if equipped).

4. Disconnect the negative battery cable.

WARNING:  To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the
supplemental restraint system (SRS) deactivation/reactivation procedure.

5. Reactivate the supplemental restraint system (SRS). 
6. Connect the negative battery cable.
7. With all restraint system diagnostic tools removed, prove out the supplemental restraint system (SRS). 

All vehicles

10. Check the active restraint system for correct operation.

Sensors and Switches - Body and Frame > < Front Seat Track - 60 Percent Bench|Page 3920