B2500 SE Cab Plus 2WD L4-2.5L VIN C (1999)
4. Drive the inner pinion bearing cup into the axle housing using Driver Handle SST 49 F027 003 and Pinion Bearing Cup Replacer SST 49 UN01
035.
Caution: Whenever the cups are replaced, the pinion bearings must also be replaced.
Note: If a feeler gauge can be inserted between a cup and the bottom of its bore at any point around the cup, the cup is not properly seated.
5. Make sure the cups are correctly seated in their bores. If a feeler gauge can be inserted between a cup and the bottom of its bore at any point
around the cup, the cup is not correctly seated.
6. Install the original oil slinger and rear bearing onto Middle Pinion SST 49 8531 565.
7. Install Collar B SST 49 UN27 004, and O-ring to Middle Pinion SST 49 8531 565 and install them into the rear axle casing.
8. Install Collar A SST 49 UN27 003, yoke and washer.
9. Tighten the nut on Middle Pinion SST 49 8531 565 making sure the yoke can be turned by hand.