B2500 SX Regular Cab 2WD L4-2.5L VIN C (1999)
7. Use the above procedure to check the piston travel with the newly selected reverse band servo piston and rod (if required) to make sure that the
piston travel is 3-5.6 mm (0.120-0.220 in). Remove the servo gauge and the reverse band servo return spring.
^
Grooves are located on reverse servo rod.
8. Install the selected reverse band servo piston and rod.
1) Install the reverse band servo piston and rod assembly.
2) Install a new reverse servo separator plate cover gasket.
3) Install the reverse band servo cover.
^
Loosely install the reverse servo piston cover bolts.
4) Tighten the servo cover bolts in the sequence shown.