B3000 V6-3.0L (2007)
Parking Brake Cable: Service and Repair
Front
PARKING BRAKE CABLE - FRONT
Removal and Installation
Note:
^
Make sure the parking brake control is fully released.
1. Relieve the tension on the parking brake system.
^
Pull down on the parking brake intermediate cable.
^
Insert a 4 mm (5/32 inch) drill bit or equivalent retainer in the parking brake control.
2. Remove the LH fender splash shield.
3. Disconnect the front parking brake cable from the parking brake intermediate cable at the cable union.
4. Compress the clip and separate the front parking brake cable and conduit from the frame bracket.