B3000 V6-3.0L (2007)
Air Bag Deactivation Switch: Service and Repair
PASSENGER AIR BAG DEACTIVATION (PAD) SWITCH
Passenger Air Bag Deactivation (PAD) Switch
NOTE: Vehicle with consolette tray shown.
Removal and Installation
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
A repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic
procedure again.
1. Depower the SRS. See DEPOWERING AND REPOWERING.
2. Remove the 2 instrument panel (I/P) center finish panel screws.
3. Pull out to detach the 4 retaining clips and partially remove the I/P center trim panel.
4. Disconnect the passenger airbag deactivation indicator electrical connector.
5. Remove the 2 screws from the passenger airbag deactivation indicator and remove it from the I/P center finish panel.
6. To install, reverse the removal procedure.
7. Repower the SRS. See DEPOWERING AND REPOWERING.