B3000 V6-3.0L (2007)
Ignition Switch: Initial Inspection and Diagnostic Overview
Inspection and Verification
1. Verify the customer concern.
Visual Inspection Chart
2. visually inspect for obvious signs of mechanical or electrical damage.
3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
NOTE: Make sure to use the latest scan tool software release.
4. If the cause is not visually evident, connect the IDS or equivalent tester to the data link connector (DLC) and select the vehicle to be tested from
the IDS or equivalent tester menu.
NOTE: The vehicle communication module VCM) LED prove-out confirms power and ground from the DLC are provided to the VCM.
5. If the IDS or equivalent tester does not communicate with the VCM.
-
Check the VCM connection to the vehicle.
-
Check the IDS or equivalent tester connection to the VCM.
-
See PINPOINT TEST 8: NO MODULE/NETWORK COMMUNICATION NO POWER TO THE DIAGNOSTIC TOOL See: Body and
Frame/Body Control Systems/Testing and Inspection/Pinpoint Tests/Communication Network/Pinpoint Tests/Pinpoint Test 8: No
Module/Network Communication - No Power to the Diagnostic Tool, to diagnose no communication with the scan tool.
6. If the scan tool does not communicate with the vehicle.
-
Verify the ignition key is in the ON position.
-
Verify the scan tool operation with a known good vehicle.
-
See SYMPTOM TROUBLESHOOTING CHART - COMMUNICATIONS NETWORK, See: Body and Frame/Body Control
Systems/Testing and Inspection/Symptom Related Diagnostic Procedures/Symptom Troubleshooting Chart/Communication Network to
diagnose no response from powertrain control module.
7. Carry out the network test:
-
If the scan tool responds with no communication for one or more modules, see SYMPTOM TROUBLESHOOTING CHART -
COMMUNICATIONS NETWORK. See: Body and Frame/Body Control Systems/Testing and Inspection/Symptom Related Diagnostic
Procedures/Symptom Troubleshooting Chart/Communication Network
-
If the network: test passes, retrieve and record the continuous memory diagnostic trouble codes (DTCs).
8. Clear the continuous DTCs and carry out the self-test diagnostics for the SJB.
9. If the DTCs retrieved are related to the concern, see SMART JUNCTION BOX (SJB) DIAGNOSTIC TROUBLE CODE (DTC) INDEX See:
Body and Frame/Body Control Systems/Testing and Inspection/Symptom Related Diagnostic Procedures/Symptom Troubleshooting Chart/Smart
Junction Box (SJB) For all other DTCs, see DIAGNOSTIC TROUBLE CODE (DTC) INDEX - B, C AND U CODES.
10. If no DTCs related to the concern are retrieved, see SYMPTOM TROUBLESHOOTING CHART - WIPERS AND WASHERS. See: Wiper and
Washer Systems/Testing and Inspection/Symptom Related Diagnostic Procedures
