B3000 4WD V6-3.0L OHV (1995)
Brake Rotor/Disc: All Technical Service Bulletins
Brake Rotor - Machining and Replacement Criteria
Bulletin No.: 001/96
Issued: 02/07/96
Revised:
Category
P
Applicable Model/s
All Models
Subject
BRAKE ROTOR MACHINING AND REPLACEMENT CRITERIA
APPLICABLE MODELS
All Models with Disc Brakes
DESCRIPTION
Policies for warrantable repair and replacement of brake rotors are described in this bulletin. Follow these guidelines to ensure proper repairs for brake
problems.
Brake Judder:
1.
Measure the thickness of the rotor.
^
If, after machining, the remaining thickness will be below the minimal allowable thickness, replace the rotor. Refer to the workshop manual for
allowable thickness.
^
If the rotor thickness meets or exceeds allowable thickness, proceed to step 2.
2.
Machine the rotors using an "on the-car" brake lathe.
3.
Follow the detailed repair procedures located in Service Bulletin, Category P, 001/95 and the applicable workshop manual.
Other Than Brake Judder:
1.
Inspect the rotor(s) for cracks.
^
If cracks are not found, refer to the table for repair/replacement criteria. Do not replace the rotor(s).
If cracks are found, replace the rotor.
