B3000 4WD V6-30L OHV (1995) Front Wheel Speed Sensor - Service and Repair
Wheel Speed Sensor: Service and Repair
Front Wheel Speed Sensor
1. Disconnect wheel speed sensor connector at wiring harness, then remove sensor mounting bolt and sensor.
2. Reverse procedure to install, noting the following:
a. Torque front wheel speed sensor mounting bolt to 68 - 92 in.lb.
b. Ensure rear wheel speed sensor air gap is 0.005 - 0.045 inch and mounting surface is clean.
c. Ensure rear wheel speed sensor pole piece is free of metal debris and O-ring is in satisfactory condition.
d. Torque rear wheel speed sensor mounting bolt to 25 - 30 ft.lb.