B3000 DS Cab Plus 2WD V6-3.0L OHV (2001)
2. Use two pry bars and push down on the pry bars.
3. Remove the differential case.
4. Remove Differential Housing Spreader SST 49 UN01 026 and Spreader Adapter SST 49 UN01 027.
13. Measure the pinion bearing preload.
-
Use a Nm (lb/inch) beam type torque wrench to measure the torque required to maintain rotation of the pinion and record the measurement for
reference during assembly.
14. Index mark the companion flange to the pinion stem.
15. Use Coupling Holder SST 49 S120 710 to remove the pinion nut.
16. Use a 2jaw puller to remove the companion flange.
Warning: Gear teeth may have sharp edges. When handling gear, use care to avoid personal injury.
Caution: Use a soft mallet to drive the pinion out of the axle housing.
17. Remove the pinion from the axle housing.
1. Hold the pinion inside the axle housing.
2. Use a soft face hammer to remove the pinion from the axle housing.
18. Install the differential bearing caps and tighten the four bolts.
