B3000 DS Regular Cab 2WD V6-3.0L OHV (2002)
Brake Fluid Pressure Sensor/Switch: Service and Repair
BRAKE PRESSURE SWITCH REMOVAL/INSTALLATION
1. Disconnect the Brake Pressure Switch electrical connector N-138
2. Remove the Brake Pressure Switch
3. Fill the new Brake Pressure Switch with High Performance DOT 3 Brake fluid
4. Install the Brake Pressure Switch into the Brake Master Cylinder
5. Torque the Brake Pressure Switch to 17 Nm (13 lb-ft)
6. Connect the Brake Pressure Switch electrical connector N-138
7. Bleed the brake system .
