Recall - Cruise Control Switch Overheating (5709J Nov 09)
2. With the cruise control servo disconnected, use shop air to blow the CCDS harness electrical connector and the servo connector dray of any trace of
brake fluid. Do not use any type of solvent to clean the connectors.
3. Apply a 5mm (3/16 in) high bead of electrical grease across the entire width and length of the servo vehicle harness connector
NOTICE:
Be sure to apply an adequate amount of electrical grease to the vehicle harness connector only. DO NOT apply the electrical grease directly to the
connector of the servo module.
4. Reconnect the harness to the servo module.
5. Proceed to "E. CAMPAIGN LABEL INSTALLATION".
E. Campaign Label Installation
E. CAMPAIGN LABEL INSTALLATION
