B3000 SE Cab Plus 4 4WD V6-3.0L OHV (2000)
Oil Pressure Sender: Testing and Inspection
Oil Pressure Switch Inspection
OIL PRESSURE SWITCH INSPECTION
1. Remove the oil pressure sensor.
2. Screw Oil Pressure Gauge SST 49 0187 280 into the oil pressure switch installation hole.
3. Run the engine at 2500 rpm and note the engine readings.
4. If pressure is not within specification (40 - 60 psi, 276 - 413 kPa, 2.8 - 4.2 kgf/cm2), refer to ENGINE SPECIFICATIONS - 3.0L, for further
diagnosis.
5. Apply sealant to oil pressure switch threads.
6. Remove Oil Pressure Gauge SST 49 0187 280 and install switch.
Tightening torque 11 - 24 Nm (1.1 - 2.4 kgf.m, 8 - 18 ft. lbs.)