B3000 SE Cab Plus 4 4WD V6-3.0L OHV (2000)
6. Balance the propeller shaft.
1. Install two stainless steel screw-type hose clamps on the propeller shaft with the clamp screws opposite the mark.
2. Tighten the hose clamps starting at the pinion yoke end of the propeller shaft.
7. Run the vehicle at baseline speed.
8. If vibration is still evident, rotate the clamps away from each other until balanced and test
9. If necessary, continue to rotate the clamps apart in smaller increments and test. If vibration still exists, repeat the procedure at the front of the
propeller shaft.
10. Install the tire and wheel assembly.
11. Road test the vehicle.