B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
Brake Master Cylinder: Service and Repair
Brake Fluid Reservoir
REMOVAL / INSTALLATION
1. Disconnect the brake fluid level switch.
2. Use a suitable suction device to drain the master cylinder reservoir.
3. Carefully pry up on the brake master cylinder reservoir to remove.
NOTE: Whenever replacing the brake master cylinder reservoir, replace the grommets.
4. Install the brake master cylinder reservoir.
1) Insert the grommets in the brake master cylinder.
2) Press the master cylinder reservoir into the grommets until it snaps.
3) Connect the brake fluid level switch.
4) Fill the brake master cylinder reservoir with appropriate brake fluid.
