B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
5.
Disconnect and remove the speed control cable from the speed control servo.
6.
Connect the new speed control cable to the speed control servo.
7.
Connect the speed control cable to all routing clips.
8.
Connect the speed control cable accelerator bracket
9.
Connect the speed control cable to the throttle body cam or accelerator cable.
1O.
Adjust the speed control cable as follows:
^
Remove the adjusting clip from the cable housing.
^
Cycle the throttle body cam 2-3 times to remove all slack from the speed control cable.
^
Back off the cable housing One (1) notch.
^
Insert the adjusting clip into the cable housing.
Note
^
The speed control cable MUST NOT be pulled tight for proper operation.
11.
Install the snow shield on the throttle body.
D.
CAMPAIGN LABEL INSTALLATION
Complete an "Authorized Modifications Label" with the recall number written on the sticker and affix to driver's side door under the door latch. Refer
back to the illustration under "A. VEHICLE INSPECTION PROCEDURE".
Attachment III - Owner Letter
1998-99 B2500, B3000 and B4000 Cruise Control Cable
IMPORTANT SAFETY RECALL NOTICE
Dear Mazda Owner:
This notice is being sent to you in accordance with the requirements of the National Traffic and Motor Vehicle Safety Act.
Mazda Motor Corporation has determined that a defect, which relates to motor vehicle safety, exists in certain 1998-99 B2500, B3000 and B4000
