B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
Air Bag: Service and Repair
Removal/Installation
Driver-Side Air Bag Module
NOTE:
^
Repair is made by replacement only. If a part is replaced and the new part does not correct the condition, install the original part and perform the
diagnostic procedure again.
1. Disconnect the battery ground cable.
2. Remove in order shown in figure.
3. Install in reverse order of removal.
Passenger-Side Air Bag Module
1. Disconnect the battery ground cable.
2. Open the glove compartment door to access mounting screws.
3. Remove the two screws (1).
4. Pull out the passenger-side air bag module to access connector.
5. Disconnect the electrical connector (2).
6. Remove passenger-side air bag module (3).
7. Install in reverse order of removal.
NOTE:
^
Repair is made by replacement only. If a part is replaced and the new pant does not correct the condition, install the original part and perform the
diagnostic procedure again.