B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
5. Install the pinch bolt and nut.
(1) Position the upper arm into the front wheel knuckle.
(2) Install the pinch bolt and nut.
6. Position the axle halfshaft into the wheel knuckle bore.
CAUTION: Make sure that no dirt or foreign material is present on the axle main seal before or after applying grease to seal. Failure to do so will
cause the axle main seal to fail resulting in the loss of vacuum sealing.
7. Apply a coating of high temperature wheel bearing grease or equivalent to the axle main seal prior to seating the axle shaft against the main seal.
CAUTION: Install the cotter pin into the lower ball joint from outboard to inboard. Failure to do so will cause damage to the wheel and tire
assembly.
8. Connect the front suspension lower arm to the front wheel knuckle.
(1) Position the lower ball joint into the front wheel knuckle.
(2) Install the castellated nut.
(3) Install a new cotter pin.
9. Install the tie rod end castellated nut.
(1) Position the tie rod end.
(2) Install the castellated nut.
(3) Install a new cotter pin.
10. Position the torsion bar insulator.
