B4000 2WD V6-4.0L SOHC (2003)
Electronic Brake Control Module: Service and Repair
ABS CONTROL MODULE REMOVAL / INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the three hydraulic control unit mounting bolts.
Tightening torque 7 - 9 Nm (71 - 92 kgf-cm, 63-79 inch lbs.)
3. Disconnect the two electrical connectors.
4. Remove the 4 bolts and ABS control module.
Tightening torque 1 - 2 Nm (10.2 - 20 kgf-cm, 9-17 inch lbs.)
5. Install in reverse order of removal.
6. Reprogram control module.
ABS CONTROL MODULE REPROGRAMMING