B4000 SE Regular Cab 4WD V6-4.0L OHV (1999)
14. Install the alignment pins into the transmission case.
15. Install a new gasket and separator.
Note:
^
Make sure main control to case gasket is properly aligned.
^
Use petroleum jelly to hold gasket in place.
16. Install the control valve body assembly.
1) Position the assembly using the SSTs as a guide.
Note: The main control valve body bolts will be tightened in later steps.
2) Loosely install the four M6 x 45mm main control valve body bolts.
3) Loosely install the two M6 x 35mm main control valve body bolts.