B4000 SE Regular Cab 4WD V6-4.0L OHV (1999)
CONSUMER NOTICE: The information and instructions in this bulletin are intended for use by skilled technicians. Mazda technicians utilize the proper
tools / equipment and take training to correctly and safely maintain Mazda vehicles. These instructions should not be performed by "do-it-yourselfers."
Consumers should not assume this bulletin applies to their vehicle or that their vehicle will develop the described concern. To determine if the
information applies, consumers should contact their nearest authorized Mazda dealership.
6.
Install the modified transfer case output flange using SST 205495. Then install spacer, washer, and flange nut.
Tightening torque
339-380 N.m (250-280 ft-lbf).
Note
The flange nut has a self locking feature and must be replaced during installation.
7.
Using a paint pencil/pen, write the current date and this Service Bulletin's number on the output flange.
8.
Install the propeller shaft assembly and tighten nuts. See Workshop Manual for additional information.
Tightening torque
94-123 N.m (70-95 ft-lbf)
Note
Future service of transfer case rear output flange will require the use of a Damper Remover Tool for disassembly.
9.
Verify repair.
PART(S) INFORMATION
Part Number
Description
Qty
Notes
ZZR0-17-020
Output Flange (Companion)
1
---
ZZLO-17-284
Nut
1
---
WARRANTY INFORMATION
Note
This information applies to verified customer complaints on vehicles covered under normal warranty. Refer to the SRT microfiche for warranty term
information.
Warranty Type
A
Symptom Code
82
Damage Code
97
Part Number Main Cause
See PART(S) INFORMATION
Quantity
1
Operation Number/Labor Hours
L0102BRX/1.0